Subversion Repositories SvarDOS

Rev

Rev 2103 | Blame | Compare with Previous | Last modification | View Log | RSS feed

# Messages used by pdTree v1 and FreeDOS tree 3.6
# Each line is limited to 159 characters unless MAXLINE is changed,
# but if possible should be limited to 79 per line, with a \n
# added to indicate go to next line, max 2 lines.
# The messages are split into sets,
# where each set corresponds to a given function in pdTree.
# Set 1, is for main and common strings.
# Many of the strings are used directly by printf,
# so when a %? appears, be sure any changes also include the %?
# where ? is a variable identifier and format.
# Note: only \\, \n, \r, \t are supported (and a single slash must use \\).
#

# main [Set 1]
1.2:Dizin PATH listelemesi\n
# Must include %s for label
1.3:%s disk b”lm i‡in dizin PATH listelemesi\n
# Must include %s for serial #
1.4:B”lm seri numaras %s\n
1.5:Alt dizin mevcut de§il\n\n
1.6: --- Srdrmek i‡in bir d§meye basn ---\n

# showUsage [Set 2]
2.1:Bir disk b”lmnn veya yolun dizin yapsn grafik bi‡iminde g”rntler.
2.2:\t
2.3:TREE [src:][yol] [/F] [/A]
2.4:\t
2.5:  /F  Her bir dizindeki dosya adlarn g”rntler.
2.6:  /A  GeniŸletilmiŸ karakterler yerine ASCII kullanr.

# showInvalidUsage [Set 3]
# Must include the %s for option given.
3.1:Ge‡ersiz anahtar - %s\n
3.2:Kullanm bilgisi i‡in TREE /? yazn.
3.3:€ok fazla parametre - %s\n

# showVersionInfo [Set 4]

# showInvalidDrive [Set 5]
5.1:Ge‡ersiz src belirtimi\n
# showInvalidPath [Set 6]
# Must include %s for the invalid path given.
6.1:Ge‡ersiz yol - %s\n
# misc error conditions [Set 7]
# showBufferOverrun
# %u required to show what the buffer's current size is.
7.1:Hata: Belirtilen dosya yolu olabilecek en byk arabelle§i aŸyor (%u bayt)\n
# showOutOfMemory
# %s required to display what directory we were processing when ran out of memory.
7.2:žu altdizinde bellek yetersiz: %s\n
#
# deprecated [Set 8]
# 8.1 - 8.10 reserved for option selection characters in earlier releases.
# parseArguments [Set 8] contains the Character[s] used for
#   argument processing.  Only the 1st character on a line is used.
# Primary character used to determine option follows, default is '-'
8.1:/
# Secondary character used to determine option follows, default is '/'
8.2:-