SvarDOSSvarDOS Packages

BlueGreycalmElegant

Català-Valencià – Catalan中文 – Chinese (Simplified)中文 – Chinese (Traditional)Česky – CzechDansk – DanishNederlands – DutchEnglish – EnglishSuomi – FinnishFrançais – FrenchDeutsch – Germanעברית – Hebrewहिंदी – HindiMagyar – HungarianBahasa Indonesia – IndonesianItaliano – Italian日本語 – Japanese한국어 – KoreanМакедонски – Macedonianमराठी – MarathiNorsk – NorwegianPolski – PolishPortuguês – PortuguesePortuguês – Portuguese (Brazil)Русский – RussianSlovenčina – SlovakSlovenščina – SlovenianEspañol – SpanishSvenska – SwedishTürkçe – TurkishУкраїнська – UkrainianOëzbekcha – Uzbek

Compare Revisions

• This comparison shows the changes necessary to convert path

  → /install/nls/ @ 48

  → /install/nls/ @ 49

  ↔ Reverse comparison

• Compare Path:	Rev

  With Path:	Rev

Ignore whitespace Rev 48 → Rev 49

/install/nls/install.en
9,7 → 9,7
0.0:SVAROG386 INSTALLATION
0.1:Install Svarog386
0.2:Quit to DOS
0.3:Create an automatic partition
0.3:Create a partition automatically
0.4:Run the FDISK partitioning tool
0.5:Press any key...
0.6:Proceed with formatting
28,7 → 28,7
#
### DISK SETUP ###
# lines 3.0 to 3.3 are a single (multi-line) message and need to be indented nicely
# lines 3.0 to 3.3 are a single (multi-line) message and need to be indented nicely.
# also, no line shall be longer than 76 characters
3.0:ERROR: Drive %c: could not be found. Perhaps your hard disk needs to be
3.1: partitioned first. Please create at least one partition on your